YHGL ^© Software  

Printing the Results

Before printing, the user should set up the printer by clicking on Print Setup under the File menu. For printing, the user should click on Print under the File menu, or just click on the Print button on the toolbar.  Then a "YHGL - Print" form will appear with four different sections, in addition to the Print and Cancel buttons section (see Fig. 10).

The first section is located on the upper left side of the Print form (it is here where the user should start).  In this section there are three options, only one of which can be selected at a time.  The three options are:

- Print the Numerical Results only.

- Print the Graphical Results only.

- Print Both Numerical and Graphical Results.

The second section is located on the upper right side of the Print form.  In this section there are four categories that can be selected in any combination (i.e., the user can select one of them or two or three, or all).  But the user should select at least one, or otherwise nothing will be printed.

The third section is located in the middle at left of the Print form. The user must fill out the number of desired copies, even if it has already been entered in Print Setup form.  Otherwise, nothing will be printed.

The fourth section is located in the middle at the right of the Print form.  In this section the user must select the graph type as 2D-Bar or 3D-Bar for the graphical results.

Note: The “select the graph type” section will not work with the "Numerical Results" option, but it is required for both "Graphical Results" and "Both Graphical and Numerical Results" options.  The user must select the graph type for those two options; otherwise no graphs will be printed.